Publicidad
Idiomas disponibles
Idiomas disponibles
BV 5030 - BV 5025
BEFORE THE FIRST USE
After unpacking the blender, wash everything except the blender base in hot, soapy water. Do not
place in dishwasher. Wipe the blender base with a damp cloth or sponge. Do not immerse the base in
water. Care should be taken when handling the blades, as they are very sharp.
ASSEMBLING
Important: Always inspect cutting blades for broken, cracked or loose blades. If jar-cutting blades are
damaged, do not use.
Make sure blender is unplugged.
1.
Place blender base on clean, dry surface.
2.
Make sure that the jug is properly assembled (jug, silicon gasket, blade and black nut)
3.
The blade assembly must be firmly screwed into the jar. If not, it may loosen when the motor is
4.
turned on.
The jar should be properly placed into the base. Insert and spin it clockwise.
5.
Plug cord into outlet.
6.
Put ingredients in jar. Place hand on jar.
7.
Process food or beverages. Spin the button on control panel to start blender. It is recommended
8.
to place a hand on the lid when blending.
Always turn blender OFF and wait until blades have stopped rotating before removing jar.
9.
To remove jar after blending complete, spin it anticlockwise and pull up.
10.
Never place jar onto unit while motor is running.
11.
SPEED
Speeds are 1, 2 and Pulse. Pulse is a controlled cycle operation. This means it operates only while the
button is held. All other speeds are continuous cycle operate continuously at whatever speed is
selected until turn the knob to the 0 position.
FOR CONTINUOUS OPERATION
Rotate knob clockwise to desired speed setting to turn blender on. Put one hand on top the blender
jar with lid securely in place.
Do not use the appliance more than 5 minutes. After 5 consecutive minutes, let it idle for another 5
minutes.
FOR CONTROLLED CYCLE OPERATION
Press "pulse" button and hold down for about 2 seconds. Release button and allow blades to coast to
a stop. Rest one hand on top of blender jar with lid securely in place.. Repeat cycles until ingredients
reach desired consistency. Release of the "Pulse" button turns blender off.
NOTE: "Pulse" button can be held longer than 2 seconds as needed, but it is recommended not to
abuse of this function to avoid overheating.
HINTS FOR BEST USE
To add foods when blender is operating, remove filler-cap from the main jar cover and add
−
ingredients through the opening.
If using your blender to make salsa or other recipes using tomatoes, onions and/or other
−
vegetables, you may have better results using a slower speed function.
10
Publicidad
