PROBLEM
Pressing the main switch
(1) to position "I", the
motor buzzes, but does
not start.
The cleaner does not
deliver hot water
CAUSE
Unsuitable electrical system and/
or extension lead
There is not enough fuel in the
tank.
The fuel filter is dirty.
The boiler's safety thermostat has
tripped.
SOLUTION
Check the instructions for connecting
up to the mains power supply have
been followed correctly (refer to the
INSTRUCTIONS MANUAL – SAFETY
INSTRUCTIONS), especially as regards the
use of an extension lead.
Top up with fuel.
F o l l o w t h e i n s t r u c t i o n s i n
"SUPPLEMENTARY MAINTENANCE".
Leave the cleaner to cool down for a few
minutes so the safety device can reset.
SHOULD IT TRIP AGAIN, DO NOT USE THE
CLEANER AND CONTACT A QUALIFIED
TECHNICIAN.
GB
27