Makita DJR181 Manual De Instrucciones página 7

Hook (For DJR181)
006902
CAUTION:
Depress the lock-off button from A side to lock the
•
switch trigger in the OFF position. (See the section
titled " switch action " .)
Never hook the tool at high location or on
•
potentially unstable surface.
The hook is convenient for hanging the tool temporarily.
To use the hook, simply lift up hook until it snaps into the
open position.
When not in use, always lower hook until it snaps into the
closed position.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Installing or removing the saw blade
CAUTION:
Always clean out all chips or foreign matter
•
adhering to the blade, blade clamp and/or slider.
Failure to do so may cause insufficient tightening of
the blade, resulting in a serious injury.
To install the saw blade, always make sure that the blade
clamp lever is in released position
cover before inserting the saw blade. If the blade clamp
lever is in fixed position, rotate the blade clamp lever in
the direction of the arrow so that it can be locked at the
released position .
1
2
005787
1. Hook
1
on the insulation
1. Blade clamp
sleeve
2. Released
position
3. Fixed position
3
Insert the saw blade into the blade clamp as far as it will
go. The blade clamp lever rotates and the saw blade is
fixed. Make sure that the saw blade cannot be extracted
even though you try to pull it out.
1
005788
CAUTION:
If you do not insert the saw blade deep enough, the
•
saw blade may be ejected unexpectedly during
operation. This can be extremely dangerous.
If the lever is positioned inside the tool, switch on the
tool just a second to let the blade out as shown in the
figure.
Remove the battery cartridge from the tool.
To remove the saw blade, rotate the blade clamp lever in
the direction of the arrow fully. The saw blade is removed
and the blade clamp lever is fixed at the released
position .
1
006665
NOTE:
Keep hands and fingers away from the lever during
•
the switching operation. Failure to do so may cause
personal injuries.
If you remove the saw blade without rotating the
•
blade clamp lever fully, the lever may not be locked
in the released position . In this case, rotate the
blade clamp lever fully again, then make sure that
the blade clamp lever locked at the released
position .
7
1. Blade
1. Blade clamp
lever