COFAN 0900 0151 Manual De Instrucciones página 22

Moisture blowing 1. Water in tank.
out of tool.
2. Water in the air lines/hoses.
Ratchet slowly or 1. Lack of lubrication.
Does not ratchet.
2. Tool regulator set in wrong
position.
3. In-line regulator or compresor
regulator set too low.
Ratchet rapidly 1. Worn ratchet mechanism.
But does not
remove
bolts.
Does not ratchet. 1. Worn ratchet mechanism.
General Troubleshooting Guide
1. Drain tank. (See air compressor manual).
Oil tool and run until no water is evident.
Oil tool again and run 1-2 seconds.
2-1. Install a water separator/filter.
Note: Separators only work properly when the air
passing through the separator is cool. Locate the
separator/filter as far as possible from
the compressor.
2-2. Install an air dryer.
1. Lubricate the air motor and the impact
mechanism.(See lubrication section of
this manual)
2. Adjust the regulator setting of the tool.
3. Adjust regulators in the air system.
1-1. Replace ratchet mechanism.
1-2. Return ratchet wrench to your supplier for repair.
1-1. Replace ratchet mechanism.
1-2. Return ratchet wrench to your supplier for repair.
ENGLISH
20