TRP XF 105 Instrucciones De Montaje página 12

COMPACT N&D
EN
Insert power supply cable splice through the
4
rear feed through. To make this easier, use
soapy water on the feed through and wiring.
Insert the wiring terminals on the power supply
support studs.
Insert positive wires (+) (Blue and Red) and
5
negative (-) (Brown) wires on the power supply
support studs and secure with flat washers, Ø
6 stainless steel grower washers and stainless
steel M6 nut. Tighten nuts to a tightening
torque of 4.75 ± 10% Nm.
5
Stud M6
Grower washer Ø 6
Flat washer Ø 6
Flat washer Ø 6
In gap A insert power cable terminals.
4
M6 Nut
A
M6 Nut
5
12
®
4