Product Disposal - BATSI MIE210MLP Manual De Uso

INTRODUCTION
This instruction manual has been written by the controller manufacturer and is an exclusive part
of the product. The operations contained are addressed to properly trained and qualifi ed per-
sonnel. It is recommended to be read and stored for future reference.
TERMS OF USE
BATSI® recommends the installation of all devices, equipment and materials, complying with
European Directives 2006/42 / EC (Machinery Directive), 2014/30 / EU and subsequent modifi ca-
tions (low voltage electrical equipment). Non-EU countries, in addition to existing national stan-
dards and for a suffi cient level of safety, it is also recommended to comply with the indications
contained in the above Directives.

PRODUCT DISPOSAL

In accordance with the EU Directive 2012/19 / EU on Waste Electrical and Electronic Equipment
(WEEE), this electronic product can not be disposed of with other unclassifi ed waste. Dispose of
this equipment by returning it to a local collection point for recycling.
MIE210MLP MODULE OPERATION
The MIE210MLP module is capable to detect the exact moment when the minimum product
level has been reached in a tank. The equipment has the possibility of:
Detect two diff erent levels of the same tank (for example middle and minimum).
Detect two diff erent minimum levels of a diff erent tanks.
Detect only one minimum level.
When the minimum level has been detected,
"MINIM" will be shown and an acoustic warning
will be emitted. The acoustic warning is diff e-
rent for every level.
MINIMUM LEVEL ALARM
The MIE210MLP will emit an acoustic signal when one of the sensors detect a minimum level.
In order to stop the acoustic alarm, you just need to push the button
activate the alarm, the sensor just have to detect product again.
As long the product level is correct, "OK" will
be shown for every correct level.
in any case. To re-
4