User Instructions - Ambiano CM-202 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

User instructions

Before first use or after a long period of non-use
When using the coffee maker for the first time, it is recommended to
operate it for 2-3 full cycles without the filter or pod holder
1. Fill the water tank to the MAX line. Then plug the coffee maker into the wall
outlet.
2. Lift the release lever, take out the brew basket and remove the pod holder
and the filter and replace the brew basket.
3. Be sure the release lever is pushed all the way down and press the power to
ON and the power button will turn green. If the lever is not locked into place,
the power button will be red.
4. The 8oz and the 15oz button will light up while the power button flashes.
This means the water is heating up.
5. When all 3 buttons are lit, (30-60 seconds) and the power button is solid
green, coffee maker is ready to brew.
6. Place a suitable cup/mug on the cup rest large enough to brew 8oz to 15oz.
The ounces button will flash until brew is complete (about 1-2 minutes).
7. Continue brewing the water only, until the tank has emptied.
8. Make sure to wait about 2-3 minutes in between brews so the coffee maker
can cool.
Note: The coffee maker may produce an odor and emit smoke when switched on
for the first time, as residues from the production process are eliminated. This is
normal and does not indicate a defect or hazard.
How to brew single serve cup of coffee
1. Lift the release lever, take out the brew basket and remove the pod holder
and the filter.
2. Place a Single Serve Cup into the pod holder and press down to make sure a
hole is punched in the bottom.
3. Place the pod holder into the brew basket (without filter), making sure hole in
pod holder lines up with the brew basket.
4. Push the brew basket into the coffee maker and press down on the release
lever to lock brew basket into place.
5. Fill the water tank and plug into wall outlet.
6. The 8oz and the 15oz button will light up while the power button flashes.
This means the water is heating up.
8
User instructions

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido