Technical Data; Symbols - GGP ITALY SHT 500 Manual De Instrucciones

IDENTIFICATION OF MAIN COMPONENTS / SYMBOLS
Maximum noise and vibration levels [1]
Sound pressure level (EN 60745)
– Measurement uncertainty
Guaranteed sound power level (2000/14/EC)
Vibration level (EN 60745)
– Measurement uncertainty
[1]
Notice:
The vibration value indicated was determined with a standardized tool and can be used to make comparisons with other electric equipment
as well as temporary estimates of the load through the vibrations.
WARNING!
The vibration value may vary according to the usage of the machine and its fitted equipment, and be higher than the one indicated. Safety meas-
ures must be established to protect the user and must be based on the load estimate generated by the vibrations in real usage conditions. In
this regard, all the operational cycle phases must be taken into consideration, such as switching off or idle running.

TECHNICAL DATA

Power supply voltage
Power supply frequency
Engine Power
Cutting lenght
Cutting movements
Mass

2. SYMBOLS

1
1) If you are using the machine every day in nor-
mal conditions, you can be exposed to a noise
level of 85 dB (A) or higher. Wear safetyglas-
ses and hearing protection.
2) Warning! Danger. Failure to use this machine
correctly can be hazardous for oneself and o-
thers.
3) Read the instruction manual before using the
machine.
2 3
SHT 500 - H 500 E
dB(A)
dB(A)
dB(A)
m/s
2
m/s
2
SHT 500 - H 500 E
V~
Hz
W
cm
min
-1
Kg
4
4) Disconnect the plug from the mains before
commencing maintenance work or if the power
cord is damaged.
5) Do not leave the machine in the rain (or in damp
conditions).
EN
Model
SHT 600
84 86
3 3
98 98
2,85 2,99
1,5 1,5
Model
SHT 600
230-240 230-240
50 50
500 600
45 55
1700 1700
3,1 3,3
5
3