Oscartielle FLY Instrucciones De Uso página 15

1. Commercial name of the refrigerating display unit
2. Refrigerating display unit code
3. Refrigerating display unit serial number
4. Rating
5. Frequency
6. Max absorbed current
7. Max absorbed power
8. Max absorbed power during defrosting
9. Standard lighting power
10. Net display area
11. Type of cooling gas used
12. Weight of cooling gas loaded in each unit
13. Climatic class and reference temperature (dry bulb)
14. Electrical safety factor
15. Work schedule number
16. Work order number
17. Year of manufacture
Important: The rating plate and warning labels should never be removed. The manufacturer is not liable for any damages
caused by failure to respect this regulation.
This is to certify that the product complies with Legislative Decree no. 108 of 25/01/1992 applying EEC Directive 89/109
concerning materials and objects expected to come into contact with food products.
7 - Filling with products and use of the cabinet (startup)
With the unit unplugged, remove the plastic protection film around it and then clean it following the instructions in point 10
below.
Then plug the unit into the mains (as described in Par. 5) and switch the cabinet on, switch the light on using the switches
on the control panel on the front of the cabinet (FIG. 9 page 3). The gentle hum of the motor and illumination of the
display will indicate that the cabinet is working. The display on the front (FIG. 9 page 3) shows the working temperature of
the display case. The instruction manual for the electronic control to which the display refers is enclosed with the
instruction booklet (tampering with this device is impossible because a password is required and only a specialized expert
can intervene on it). The thermostat and gas charge are set in the factory. Tampering with the factory settings relieves the
manufacturer of any liability.
About three hours after switching the cabinet on, you can start filling it with products. Always check that the temperature
on the display of the electronic control is suitable for the conservation of the products placed in the display cabinet.
The cabinet is designed for the display of food products, which are stored at the temperature of the product, and does not
lower it. The product should therefore be placed in the cabinet only after it has been chilled to its proper storage
temperature.
For better conservation of the product we recommend:
- Do not obstruct the cold recycle vents that ensure a correct air flow.
- Leave adequate space between products to ensure good air circulation.
- When placing more products inside a partially filled cabinet, in addition to following the above instructions, it is a good
rule to place the new products underneath the existing ones.
- Never exceed the maximum loading limit clearly visible inside the unit (FIG. 10 at page 4).
8 - Prohibitions and regulations
Warning: disconnect the cabinet from the power supply in case it is not used. The power supply has to be disconnected
by the remote-control switch fitted upstream from the power socket.
Warning: Never expose the unit to the atmospheric agents. Never use direct water jets to clean the unit. Never touch or
use the unit with wet or damp feet and hands.
Warning: Never remove the protections or covers that require tools to be removed. Never, under any circumstances,
remove the cover on the electronic panel.
Warning: Never overload the unit and the shelves.
Warning: The refrigerating circuit does not cause any chemical modification of the water generated from defrosting. This
comes exclusively from the steam contained in the air circulating inside the unit. In any case, this water should always be
disposed of down the drain or sent to a water purification plant in line with current local regulations.
Warning: Any use of the unit not explicitly mentioned in this manual should be considered dangerous and the
Manufacturer cannot be held liable for any damage resulting from improper, incorrect or unreasonable use.
Warning: Do not damage the refrigerant circuit (IEC60335-2-89:2002 and changes)
Warning: Do not use electrical appliances inside the food storage compartments of the appliance, unless they are of the
type recommended by the manufacturer (IEC60335-2-89:2002 and changes)
Warning: This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use
of the appliance by a person responsible for their safety.
Warning: Children should be supervised to ensure that they do not play with the appliance.
Warning: Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance.
13