Faro Barcelona 33937 Manual Del Operario página 5

Press and hold the button for 10 seconds to switch from degree Celsius to degree Fahrenheit display.
LIGHT DELAY: Press the button to activate the light delay function, which will turn off the fan 3 minutes
later.
Temperature / Timer
Temperature / Timer
LIGHT switch: Press the button to turn ON/ OFF the light.
FAN AUTO Function
FAN AUTO function allows the fan to operate more efficiently with the use of the in-built thermal sensor.
Press the FAN AUTO button to activate FAN AUTO function, and then press the UP/ DOWN buttons to
set the temperature at what you preferred. The fan will run at the HIGH, MEDIUM, LOW or OFF speed
automatically via comparing to room temperature as following:
Room temperature is lower than setting temperature:
Room temperature is equal to the setting temperature by 0 ℃ : →
Room temperature is higher than setting temperature by 2 ℃ : →
Room temperature is higher than setting temperature by 4 ℃ : →
Press the FAN AUTO button again to turn off the FAN AUTO function.
FAN TIMER Function
Press the FAN TIMER button to activate the timer function, and then press the UP / DOWN buttons to
set the time at what you preferred. The fan and light will turn OFF at the set time. Fan timer can be cancel
anytime by setting the timer to 0 (zero hours).
LIGHT TIMER Function
Press the LIGHT TIMER buttons to activate the timer function, and then press the UP / DOWN buttons to set
the time at what you preferred. The light will turn OFF at the set time. Light timer can be cancel anytime by
setting the timer to 0 (zero hours).
NOTE: When using the FAN AUTO Function and TIMER function, ensure the remote is in the same
room or within the transmission/receiving range.
HOW TO SET THE DIMMER?
C/. Dinámica, nº1 ● Polígono Industrial Santa Rita
Tel. 902 165 166 - +34 93 772 39 49 ●
: Set the temperature and time up
: Set the temperature and time down
● 08755 Castellbisbal
Fax. +34 93 772 00 18
faro@lorefar.com
→ OFF
LOW
MED
HI
● OFF: function DIMMER,
using incandescent bulb only.
● ON : function ON/OFF , using CFL bulb.
Setting the code on the TRANSMITTER (1~4). Slide
code switches (1~4) to your choice position. Use a
small screwdriver or ball point pen to slide each switch
firmly up or down., The code setting should be the
same as RECEIVER
● Barcelona ● Sp ain
●
www.faro.es