Fault Finding - Diamant Boart MP 900 B-01 Manual De Instrucciones

10
Maintenance - repairs
- Take care to avoid accidental
damage.
- Disconnect the machine.
This consists mainly of cleaning the
machine and the plates after each time it
is used.
Replacing the pads
• Loosen the 6 screws on the top of the
plate and slide the pads to the outside.
• To fit and lock the pads repeat these
operations in the reverse order.
Replacing the brushes
• Remove the unit (6 screws) and center
the new brush (centering hub inside).
Changing the belt and adjusting the
tension :
• This change is made in the declutched
position
• Tension the belts without excess: in the
declutched position adjust the two Japy
screws on the control shaft.
• Release the lock nuts, unscrew the two
screws by the same amount, then tighten
the nuts.
Reduction gear: lubricate with Blasia's
220 Long Life synthetic oil
• Check the oil level at intervals
• Drain the oil every 10,000 hours and flush
thoroughly (approx. 0.3 liter)
• Dispose of the old oil as laid down by
the regulations in force.

FAULT FINDING

In the event of faulty operation refer to the
tables below to find a solution.
• The machine does not work
CAUSES REMEDIES
Not plugged in - Make sure that
properly or cable the supply is
damaged correctly plugged
in (plug,
extension lead,
etc)
- Check the supply
cable
No mains voltage - Test or have
tested by an
electrician
(circuit breaker,
plug, etc)
Switch defective, - Have tested by
motor cable an electrician or
damaged contact the
service
department
Motor faulty (no - Contact the
power, unpleasant service
smell) department to
have the motor
Belt broken replaced
- Contact the parts
department for a
replacement
• Difficult starting
CAUSES REMEDIES
Plate friction - Tilt the machine
stopping rotation slightly when
(sticking to the starting or move
floor) it
Single phase motor - Replace the
starting condenser condenser
• Abnormal noise from the reduction gear
CAUSES REMEDIES
Reduction gear - Check the oil
noisy level, tighten the
nuts and bolts,
etc
Reduction gear - Stop using
damaged immediately and
contact the
service
department
11 Repairs
Contact your supplier who is
S
entirely at your service to carry
A
V out repairs in the shortest time at
the best possible price.
12 Spare parts
For rapid delivery of spares and in order to
avoid any wasted time, it is necessary to
remind your supplier of the details shown
on the instruction plate on the machine with
each order, as well as the reference of the
part to be replaced.
00000000 (0)
Item number
See exploded view
13 Scrapping
In the event of deterioration and
scrapping of the machine, the
following items
disposed of in accordance with
the requirements
legislation in force.
• Main materials :
Motor : Aluminium (AL) - Steel (AC)
Motor : Copper (CU) - Polyamide (PA)
Machine : Steel sheet (AC) -
Machine : Aluminium (AL)
Réducteur : Aluminium (AL)
Réducteur : Fonte (FT) - Bronze (BR)
The instructions for use and spare parts
found in this document
information only and are not binding.
As part of our product quality improvement
policy, we reserve the right to make any
and all technical modifications without prior
notice.
Quantity
must be
of the
are for
12