Maintenance And Cleaning; Figures - Vortice DIMMER SYSTEM Manual De Instrucciones

ENGLISH
The remote control commands are shown in the table below:
max
on
o
Intensity levels that can be set with the remote control:

Maintenance and cleaning

Fig. 6
Always remove the plug from the socket before performing cleaning or maintenance.
Never clean using abrasive or chemical products.
Do not immerse any parts of the unit in water or other liquids.
Key Figure
Up arrow
Max
max
Down arrow
On
on
Off
o
Number of presses
Max
1
2
3
4
5
6
Function
Increases the level of intensity
(see intensity level table).
The TSS goes directly to maximum level .
Decreases the level of intensity
(see intensity level table).
To switch on the TSS: Press ON. The DS
will start with its "soft start", beginning at
33% of power and then, after 4 seconds,
it will return to the last previously set
power level. In the case of the first start
up, the TSS starts at maximum power
after 4 seconds (the light will be red
during operation).
To switch off the TSS: Press OFF. The
TSS will go into stand-by conditions (the
light will turn blue).
Power (W)
1500
1300
1200
1000
800
600
0
7