Pur Line Warmer Bed Manual De Instrucciones página 9

• Never use the blanket unsupervised.
• Prolonged use of the blanket at a high setting could lead to skin burns.
• Prolonged use of the blanket at a high setting could lead to skin burns.
• Never touch a blanket that has fallen into water. Unplug the blanket from the
mains outlet immediately.
• Keep the mains cable away from hot surfaces.
• Never carry, pull or turn the blanket by the mains cable and do not let the cable
get tangled.
• Do not use the blanket when wet and only use it in dry environments (not in
the bathroom or similar environments).
• The controller and cable must not be exposed to any kind of moisture.
• If a fault occurs, do not attempt to repair the blanket by yourself. Repairs must
only be carried out by an authorized specialist dealer or other suitably qualified
personnel.
• If the power supply cable is damaged, it may only be replaced by, an authorised
dealer or by qualified electricians. In order to prevent hazards, always send the
blanket in to the service centre.
• Let the blanket cool down completely before folding and storing it. Do not fold
it too tight.
• When not in use, store the blanket as follows:
- Store the blanket in its original packaging and keep it in a clean, dry place.
- Fold the power cable carefully to avoid cable breaks.
- Do not crease the blanket by placing items on top of it during storage.
• Should you have any concerns about health issues, consult your doctor
beforeusing the blanket.
OPERATION
It is recommended that the blanket to be switched on (in position 3) 30 minutes before going to
bed.
Plug the blanket into the mains outlet and turn the selector switch on the controller from position
0 to position 1.
The red power indicator will light up. You will feel the blanket gradually warming up. This will be
even more noticeable if it is covered with a quilt. If you require a higher temperature setting, turn
the switch to the position 2 or to position 3. Should the blanket get too warm for you, turn the
switch back to position 2 or to position 1. Position 2 and 3 of the blanket is intended for heating
up, only position 1 is for continuous operation. Move the selector switch to position 1 before falling
asleep.
EN
7