Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
IMPORTANT SAFETY INSTRUCTIONS
21. FIRE FASTENERS INTO WORK SURFACE ONLY. Do not drive nails nor attempt
to do so, into hard or brittle materials such as steel, concrete, or tile.
22. DO NOT DRIVE NAILS too close to the edge of the workpiece. The workpiece is
likely to split, allowing the fasteners to fly free or ricochet causing personal injury.
23. STAY ALERT. Keep hands and body away from the path of any potential fired
fastener. Watch what you are doing & use common sense. Don't operate any
tool when you are tired or under the influence of drugs or alcohol. Check pre-
scriptions to determine if there could be a problem.
24. GUARD AGAINST ELECTRIC SHOCK. Prevent body contact with grounded
surfaces: pipes, radiators, ranges, and refrigerator enclosures. Before driving
fasteners into walls, floors, or wherever "live" electrical wires may be encountered,
try to ascertain whether there is a danger of shock.
25. KEEP WORK AREA CLEAR of obstructions.
26. STORE IDLE EQUIPMENT. When the tool is not being used, it should be
cleaned, and stored in a clean dry place out of the reach of children.
27. EMPLOYERS must enforce compliance with the safety warnings and all other
instructions in this manual. Keep it available for use by everyone assigned to use
this tool.
WARNING: The warnings, cautions, and instructions detailed in this manual cannot
cover all possible conditions and situations that occur. It must be understood by the
operator that COMMON SENSE AND CAUTION ARE FACTORS that cannot be built
into this product, but MUST BE SUPPLIED BY THE OPERATOR.
UNPACKING
Check immediately that all parts and accessories are included. If anything is missing
or broken, contact your retailer or call 1.888.267.7713.
RoofingCoil Nailer
Safety glasses
S3 Hex Key
S4 Hex Key
S5 Hex Key
Air Tool Oil
Manual
Case
SPECIFICATIONS
Shoots standard 7/8", 1", 1-1/4", 1-1/2", and 1-3/4" (22mm, 25mm, 32mm, 38mm,
45mm) x 11 ga. (3.05mm / 0.120") flat, full round-head (max. head diam: 0.39" /
10mm) roofing coil nails in 120-150 nail, 15-16 degree wire-collated rolls
Operating pressure: 85-120 psi / 586 to 827 kPa / 5.9 to 8.3 bar
Padded rubber hand grip.
Non-slip green finish
Re-directable exhaust port
Adjustable shingle location guide
OPERATING PROCEDURES
1
1
1
1
1
1
1
1
Air consumption: 0.1 cubic foot / 2.8 litres per cycle
@ 100 psi / 689 kPa
Nail Capacity: 120 -150 nail coil
Air Inlet: 1/4" NPT
Tool weight: 5.9 lb / 2.7 kg
Pkg. weight: 9.5 lb / 4.2kg
FEATURES
Carbide inserts in the nose of the tool prevent wear
on the nose and firing chamber from abrasive shingles
3
Publicidad
Tabla de contenido
