Air Source; Preparing The Tool - Superior CN45R Manual Del Operador

OPERATING PROCEDURES
SET UP
Your roofing coil nailer is fully assembled when you receive it. See the recommended
air system setup below.
Be sure that the couplers are set up so that the air hose is depressurized when
adding or removing components from the system.

AIR SOURCE

Nailer
The CN45R is designed to operate on clean, dry, compressed air, regulated at 85-
120 psi / 586 to 827 kPa / 5.9 to 8.3 bar. The preferred system would include a
filter, a pressure regulator, and an automatic oiler located as close to the tool as
possible (within 15 feet / 5 meters is ideal).
All compressed air contains moisture and other contaminants that can harm the
internal components of the tool. An air line filter will remove most of these and
significantly prolong the life of the tool. If an in-line oiler is not available, place 5
or 6 drops of oil into the tool's air inlet at the beginning of each workday.
The tool can be equipped with a male 'quick connector.' To prevent accidental
cycling when disconnected, it must always be connected to the air supply in
such a way that all air pressure in the tool is released when the coupling is
disconnected.
CAUTION:
All air line components (including hoses, pipe, connectors, filters, & regulators,
etc.) must be rated for a minimum working pressure of 150 psi / 1034 kPa /
10.3 bar or 150% of the maximum system pressure, whichever is greater.
Disconnect the tool from the air supply before performing maintenance, clearing
a jammed fastener, leaving the work area, moving the tool to another location,
or handing it to another person.

PREPARING THE TOOL

1. After reading and understanding this entire manual, connect tool to air supply.
2. Turn on the air compressor and adjust the regulator to the proper pressure for the
fastener size you are using. (See Using the Tool, below with regard to adjusting
this.)
CAUTION:
Keep the tool pointed away from yourself and others at all times.
Always connect the tool to air supply before loading fasteners.
Do not load fasteners with safety or trigger depressed.
Always wear approved safety glasses and hearing protection when preparing or
operating this tool.
Never use a tool that leaks air or needs repair.
LOADING FASTENERS
1. Press down latch, open feeder cover and magazine cover
2. Adjust nail support to suit desired nail length. The nail support can be lifted and
rotated to three different positions that provide support for different length roofing
4
Quick Connector
Air Line
Oiler Filter
Regulator
Air Supply