Stanley FATMAX SL10LEDS Manual De Instruccion página 4

Note:
The battery/charge status LED indicator will light in one of three colors (as described in the "Reading the Battery/Charge Status LED Indicator" section)
to indicate the battery status.
Operating the unit corded
Plug the barrel tip of the supplied 12 volt DC adapter into the 12 volt DC charging port at the back of the unit. Insert the plug
end into the accessory outlet of your vehicle or other 12 volt DC power source. Operate the unit as outlined in the previous
section.
IMPORTANT: The spotlight will operate while the 120 Volt AC Adapter is attached, but will continue to draw power from the
unit's Lithium-Ion battery while the spotlight operates. This may cause the low voltage protection to activate and shut the
spotlight down. Manufacturer recommends only operating the unit in corded mode using the 12 Volt DC Adapter.
Using the Emergency Red Lens
The Emergency Red Lens snaps into place directly over the Rubber Bezel, as shown.
Using the Swing-up Stand
Lift the Swing-up Stand up, invert the unit and set it upon a flat, stable surface for hands-free operation.
Using the carry lanyard (optional accessory)
The carry lanyard may be used to carry the unit or to hang it for storage. Always adjust the slide on the cords to keep the
lanyard secure around any supporting object.
CAUTION: TO REDUCE THE RISK OF PRODUCT DAMAGE:
• When light is hung by the carry lanyard, do not shake the spotlight or object that it is hanging from. Do not hang the
spotlight from any electrical wires or anything that it is not secure.
• Only use the carry lanyard for hanging this spotlight. The carry lanyard is not intended to support additional weight. Do not
attach or hang anything additional to the spotlight or risk of breakage may occur.
CARE AND MAINTENANCE
All batteries lose energy from self-discharge over time and more rapidly at higher temperatures. When the unit is not in use,
we recommend that the battery is charged at least every 3 to 6 months.
Never submerge the unit in water. If the unit gets dirty, gently clean the outer surfaces of the spotlight unit with a soft cloth
moistened with a mild solution of water and detergent.
There are no user-replaceable parts. Periodically inspect the condition of adapters, connectors and wires. Contact manufacturer
to replace any components that have become worn or broken.
Battery replacement/disposal
BATTERY REPLACEMENT
The battery should last the service life of the unit. Service life is dependent on a number of factors including but not limited to
the number of recharge cycles, and proper care and maintenance of the battery by the end user. Contact manufacturer for any
information you may need.
SAFE BATTERY DISPOSAL
Contains a lithium-ion battery, which must be disposed of properly. Recycling is required. Failure to comply with
local, state and federal regulations can result in fines, or imprisonment. Contact your local waste management
authority to dispose of this product.
WARNINGS:
• Do not dispose of the battery in fire as this may result in an explosion.
• Before disposing of the battery, protect exposed terminals with heavy-duty electrical tape to prevent shorting (shorting can
result in injury or fire).
• Do not expose battery to fire or intense heat as it may explode.
12 volt DC Adapter plug fuse replacement
The fuse in the plug end of the 12 Volt DC Adapter protects the adapter's charging circuit. If the 120 Volt AC Adapter operates,
but the DC charging adapter does not, then this fuse may be opened (blown).
TO REPLACE THE FUSE:
1. Unscrew the end cap of the DC plug (counterclockwise).
2. Remove spring center contact and fuse.
3. Check fuse with a continuity checker.
4. If blown, locate a replacement 5 amp.
5. Replace the fuse, spring, contact and end cap.
SL10LEDS_ManualENSP_041114.indd 6-7
PLEASE
RECYCLE
6
6. Screw end cap clockwise until it is finger tight – DO NOT OVER-TIGHTEN.
7. Test for proper operation of the 12 volt DC charging adapter.
TROUBLESHOOTING
The battery/charge status LED indicator flashing green/red alternatively during charging
The unit may have shut down to protect the battery from overheating after long term operation or charging/recharging.
Unplug the AC or DC adapter and allow the spotlight to cool down approximately a half-hour before resuming charging.
The battery/charge status LED indicator does not light when charging
1. Check connection to the 12 VDC Charging Port.
2. Check connection to AC or DC power source.
3. Confirm there is a functioning AC or DC current.
4. Check that the fuse in the 12 Volt DC Adapter is not blown.
Unit will not operate in corded mode
1. Check connection to the 12 VDC Charging Port.
2. Check connection to the DC power source.
3. Confirm there is a functioning DC current.
4. Check that the fuse in the 12 Volt DC Adapter is not blown.
Unit will not operate
1. The unit may have shut down to protect the battery from overheating after long term operation or charging/recharging.
Allow the spotlight to cool down approximately a half-hour before resuming operation.
2. The battery may be completely discharged. Charge the unit following the directions.
3. If the spotlight does not operate after a cool-down period or recharging as directed, contact manufacturer at (877) 571-2391.
ACCESSORIES
Recommended accessories for use with your tool may be available from the manufacturer. If you need assistance regarding
accessories, please contact the manufacturer at (877) 571-2391.
WARNING: The use of any accessory not recommended for use with this appliance could be hazardous.
SERVICE INFORMATION
Whether you need technical advice, repair, or genuine factory replacement parts, contact the manufacturer at (877) 571-2391.
ONE-YEAR LIMITED WARRANTY
The manufacturer warrants this product against defects in materials and workmanship for a period of ONE (1) YEAR from the
date of retail purchase by the original end-user purchaser ("Warranty Period").
If there is a defect and a valid claim is received within the Warranty Period, the defective product can be replaced or repaired
in the following ways: (1) Return the product to the manufacturer for repair or replacement at manufacturer's option. Proof
of purchase may be required by manufacturer. (2) Return the product to the retailer where product was purchased for an
exchange (provided that the store is a participating retailer). Returns to retailer should be made within the time period of the
retailer's return policy for exchanges only (usually 30 to 90 days after the sale). Proof of purchase may be required. Please check
with the retailer for their specific return policy regarding returns that are beyond the time set for exchanges.
This warranty does not apply to accessories, bulbs, fuses and batteries; defects resulting from normal wear and tear, accidents;
damages sustained during shipping; alterations; unauthorized use or repair; neglect, misuse, abuse; and failure to follow
instructions for care and maintenance for the product.
This warranty gives you, the original retail purchaser, specific legal rights and you may have other rights which vary from state
to state or province to province. This product is not intended for commercial use.
Please complete the Product Registration Card and return within 30 days from purchase of the product to: Baccus Global LLC,
595 S. Federal Highway, Suite 210, Boca Raton, FL 33432. Baccus Global LLC, toll-free number: (877) 571-2391.
SPECIFICATIONS
Spotlight
Bulb: 10 watt LED
Battery: Lithium-Ion, 7.4V DC
120 Volt AC Adapter
Charger: Class 2, 12 volts DC (500mA)
12 volt DC Adapter (optional accessory)
Voltage: 12 volts DC
DC Plug Fuse: 5A
Imported by Baccus Global LLC, 595 S. Federal Highway, Suite 210, Boca Raton, FL 33432 • (877) 571-2391
RD041114
7
4/11/2014 11:44:27 AM