Kongskilde MultiEvacuator Instrucciones De Servicio página 27

Maintenance
Cleaning
• The filter (A) in the top of the
Multievacuator unit must be
cleaned regularly with a brush.
A blocked-up filter will reduce
conveying capacity. The clean-
ing interval will depend on
the material being conveyed.
To remove the filter for clean-
ing, release the two locks (B).
Disconnect the pipe from the
blower outlet and tilt up. The
filter can now be taken out.
• Check to make sure the suction
mesh (C) on the blower is not
blocked up.
• The motor air filter (D) must not
be covered. The motor must
also be protected from dirt as
this can reduce cooling efficien-
cy.
Seals
Check regularly to ensure that the
seals (E) and (F) in the Multi-
evacuator cover are in order. De-
fective seals also reduce conveying
capacity.
27