Ibiza Light WD200RX Manual De Instrucciones página 3

meters when match and they can be used far away after matching successfully.
• The unit can only be used with our WD300DMX and WD200SET IBIZA LIGHT
• With memory save function: the work mode and frequency band are kept after power off.
Functions for 3-pin male and female connectors
DMX512 signal input /output
1: Ground
2: DMX signal –
3: DMX signal +
Electric products must not be put into household waste. Please bring them to a recycling centre. Ask your
local authorities or your dealer about the way to proceed.
©Copyright Lotronic 2016
Product Overview
1. Power input
2. DMX signal input
3. Antenna
4. Signal indicator
5. CLEAR button
6. M12 fixing hole
Functions
The 16 working frequencies are selected automatically.
Operating instructions
Auto frequency selection
Press the <Auto> button on the wireless transmitter until the signal indicator
on the receiver flashes which means that the two units have matched
successfully. With memory save function, if the matching data is not
removed, the two fixtures are matched to work all the time.
Cancel matching:
Press the CLEAR button on the receiver (WD200RX) until the signal indicator
does not flash any more, which means the matching data have been
cancelled. So the receiver can work to match with other transmitters.
Match with multiple groups:
Match a group of receivers and transmitters first when you make many
groups match to work.
(Disconnect the power supply of the others and only keep one group). Then
turn on another group, never power on for matching at the same time. You
can power off the already matched fixtures if you wish.
One transmitter and multiple receivers (WD200RX):
Match one transmitter with one receiver (WD200RX) first and then power
off the receiver after matching. Match another receiver with the transmitter,
so one transmitter can work with multiple receivers after finishing matching.
Notes:
• Make sure the distance of the two controllers is between 0.6 and 10
WD200RX 3