Features; Charging The Internal Battery Of The Memory Saver - DSR INDUSTRIAL Serie Manual Del Usuario

2.

FEATURES

3
4
1. Internal battery Status Test Switch
2. Internal battery Status lights
3. Charging Status lights
4.
Internal Battery Charger Plug (On Side, Not Shown)
5. 12V DC Power Outlet (On Back, Not Shown)
6. OBD (On Board Diagnostic) Connector with a 6 Foot Cable
7. Male-To-Male Charger Cable with 8 Amp Fuse
8. Velcro Strap (not shown)
3.

CHARGING THE INTERNAL BATTERY OF THE MEMORY SAVER

IMPORTANT: CHARGE IMMEDIATELY AFTER PURCHASE, AFTER
EACH USE, AND EVERY 30 DAYS TO KEEP THE MEMORY SAVER'S
INTERNAL BATTERY FULLY CHARGED.
3.1 LED Indicators:
To check the internal battery status, press the red button on the front of
the Memory Saver.
• A red light
ately recharge the Memory Saver.
• A yellow light
may be used but should be recharged as soon as possible.
• A green light
2
5
indicates a 50% or less charge and you should immedi-
indicates a 50% to 75% charge. The Memory Saver
indicates the internal battery is fully charged.
•
1
6
3
•
7