Troubleshooting - Magen eco-Energy AquaBlue light Manual Del Usuario

Warning:
Be very careful when handling muriatic acid:
• When preparing diluted muriatic acid solution, always add acid to the water,
NOT water to the acid.
• Dilute 1 part of acid in 10 parts of water (10 solution).
• Always follow the instructions of the acid manufacturer.
Cell Cleaning:
1. Take the cell out of the water.
2. Disconnect the cell cable from the power supply.
3. Pour either diluted muriatic acid (10 solution) or undiluted white distilled vinegar
into the cell.
4. Immerse the cell in the acidic solution as describes in
the sketch below.
5. Wait for foaming to stop (5-10 minutes when using
muriatic acid, or longer for vinegar).
6. Safely dispose of the acid solution by pouring it into
your pool or other suitable drainage.
7. Rinse cell with water hose.
8. Attach cell to underwater stickers and reconnect cell
cable to power supply. Ensure connection is debris free.

Troubleshooting

The following table provides a guidelines for detecting and solving problems that
may arise when operating the generator.
No. Problem
Chlorine
1 level low
or zero
Aqua blue Light 3.indd 7 Aqua blue Light 3.indd 7
Possible Cause
The plug is not
connected to the socket
Low salinity
Cell operation time is
too short
Low stabilizer (cyanuric
acid) level
Chemical imbalance
High salinity (above
5000 ppm)
Low water temperature
(below 20°C)
Corrective Action
Connect power plug to socket.
Check the salinity level, and adjust if
necessary, (see section 4 below).
Set the plugged timer to run more
hours per day.
Check the water chemicals; the
stabilizer level should be 40-80 ppm.
If low, add stabilizer. See Chemical
Balance Table.
Check other chemicals in the water
and balance if necessary. See
Chemical Balance Table.
Check the salinity level, and adjust if
necessary, (see section 3 below).
Check water temperature, and adjust if
necessary
7
1/19/2009 12:21:48 PM 1/19/2009 12:21:48 PM