Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
2. Setting the ball joint for the
desired tilt angle
Loosen the little
n
wheel on the ball
joint
holder and set the
desired vertical or
horizontal position,
as well as the tilt
angle. Then tighten
the little wheel again.
3. Attaching a device to the holder
The lower holding tabs
n
ted to fit the size of the device.
The tabs
pushed in by pressing the buttons on the
back of the holder
Adjust both the holding tabs to fit the
size of your smartphone and make sure
that both the holding tabs are set the
same.
Insert the desired device and press
n
against the clamp
the device will simply be held by the hol-
der
5_160255_INT_Smartphonehalter_E_I_P_GB_D_160704.indd 30
behind the
[
Holder
adjustable
holding tabs
can be pulled out and
{
. Now remove the pressure from
]
can be adjus-
{
(marked "Press").
]
. This will give and
|
07.07.16 10:0
Publicidad
Tabla de contenido
