Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
the clamp so that the device is pressing
against the holding tabs and is therefore
locked. Place the device so that all side
operating elements remain freely acces-
sible.
To remove the device, simply press it
n
against the clamp
then remove the device at a slight angle.
The holder
thanks to the ball joint
installed can be put in various positions
e.g. vertical (for instance for use as a
camera) or horizontal (for instance for
the satnav function). On the back of the
holder
with which a charging cable may be
attached (cable not supplied with the
holder). Cable clips: Left cable clip for
cable thicknesses of 2.4 – 3.0 mm
Right cable clip for cable thicknesses of
3.5 – 4.1 mm.
• Cleaning and care
Do not use any cleaning agents with
alcohol or other fl ammable liquids/subs-
tances. Clean the product with a dry, lint-
free cloth.
5_160255_INT_Smartphonehalter_E_I_P_GB_D_160704.indd 31
can rotate through 360°
]
there are two cable clips
]
again until it gives,
|
, so the device
[
}
07.07.16 10:0
Publicidad
Tabla de contenido
