Cleaning And Maintenance - Imetec P8301 Instrucciones De Uso

ATTACHING and REPLACING SPACER COMBS (6A, 6B, 6C, 6D)
Spacer combs are useful for adjusting the length of the cut.
•
Fit the selected comb onto the head [Fig. D1, D2].
•
Make sure that the comb teeth are set up on the blade teeth.
INSTRUCTIONS FOR USE OF THE TRIMMER HEAD (1A) AND
THE PRECISION HEAD (1B)
•
Attach the selected head to the body of the appliance.
•
Turn the appliance on by pushing the on/off (2) switch upwards.
•
Place the head (1A, 1B) on the area where you wish to remove the
hair, holding it at a 45° angle [Fig. E].
•
Pulling your skin tight, carefully slide the blade along your skin,
against the direction of hair growth, without pressing too hard.
SPACER COMB USE (6A, 6B, 6C, 6D)
•
Attach the selected spacer comb to the body of the appliance.
•
Turn the appliance on by pushing the on/off (2) switch upwards.
•
Place the spacer comb perpendicular to the area where you wish
to remove the hair and gently slide the appliance against the
direction of hair growth [Fig. F1, F2].

CLEANING AND MAINTENANCE

WARNING! Make sure all cleaned parts
are completely dry before reusing the
appliance.
Performance and durability are enhanced by cleaning the appliance
regularly. Clean the appliance immediately after each use and when
there is hair or dirt trapped in the heads (1A, 1B).
19
EN