Weidmuller 2608C Manual De Instrucciones página 25

7. PEAK ± Button
1. Record the peak+ or peak- value in a measurement. It is usable
with AC voltage, AC current measurements. If the pressed time >2
sec, the PEAK function will enter to calibration mode, the LCD will
show "CAL" and the intemal buffer will remember the intemal op off
set voltage then back to the measure mode.
2. Response time: more than 1ms. 3.The recorded value of PEAK
function will show on the sub-display, and the value being measured
will show on the main-display.
8. MAX / MIN Button
The "MAX" displays the maximum value of measurements. The "MIN"
displays the minimum value of measurements. press MAX/MIN button
for more than 2 seconds to exit. The recorded value of MAX/MIN
function will show on the sub-display, and the value being measured
will show on the main-display.
9. Backlight Button
Press the
second.
10.HOLD Button
Press [HOLD] button to toggle in and out of the Data Hold mode.
In the data hold mode, the " HOLD" annunciator is displayed and
the last reading is held on the display.
Press [HOLD] button again to release the hold and current
readings are once again displayed.
11. Trigger
Press the lever to open the transformer. When the lever is released,
the jaws will close again.
12.Transformer jaws
Pick up the AC or DC current flowing through the conductor. The "+"
marking on the jaw indicates direction of DC current existing on the
conductor being tested which follows forward and vertically with
jaws, and reading shown on display is positive.
2608C.p65
button to activate the backlight for approximately 60
25
25
9427370000_00/06.2019
? 2 009/6/5, 下午 04:18