NOCCHI BIOX XS Manual De Uso página 7

The linear meausures in chart are in millimeters
MIN. PRIMING
TYPE
Picture
BIOX® 200/8 123mm
BIOX® 300/10 123mm
BIOX® 400/12 123mm
Pump with less than 10 mt. supply cord cannot be used in open spaces.
The min. priming level refers to completely submerged outlet. (See Pict. 1)
CHAP. 3 INSTALLA TION
Please use handlebar to remove or lift pump up.
Please use a non-return valve in case pump is connected to fixed installation with rigid piping; this will avoid liquid circulating when
pump has been turned off; use of a pipe fitting will allow easy disconnection of pump for maintenance.
Dimensions of drain well must allow max. 30 on/off cycles/hour. ( See USE AND HIS LIMITATIONS )
Please use flexible pipe connected to pump by means of plastic fitting in case of temporary use of pump.
Use a rope to immerse pump and fasten it to pump's handlebar.
®
BIOX aut is equipped with a pre-rated float switch ( See Pict. 1); please increase or decrease the free piece of float switch cable
by making it sliding through the proper seat on the handlebar, when modifying the rating of float switch.
Pumps used besides or inside swimming pools, garden ponds or similar places may have special requirements.
CHAP. 4 ELECTRIC CONNECTION
Single phase pumps are equipped with double ground contact plug at top end of supply cord ; in this case grounding is done when plugging
in.
In this case the ground wire ( yellow-green cable ) of supply cord must be connected to ground wire of electric current network.
Ensure connection to electric current network by using an omnipolar-sectionned magneto thermic circuit-breaker.
This will ensure effective disconnection from electric current network.
MIN. DRAINAGE
LEVEL LEVEL
A B
45mm
45mm
45mm
DANGER
Electric shock risk
REMARK
REMARK
REMARK
DANGER
Electric shock risk
DANGER
Electric shock risk
Single phase version
Three phase version
START LEVEL STOP LEVEL
D
C
250mm
370mm
300mm
400mm
300mm
400mm
When installing, please ensure pump is disconnected
from electric current network.
Make sure that float switch turns
off pump, when at min. level of liquid.
Make sure no obstacles stand in the way of
float switch, during up/down swinging.
Ensure tension and frequency of pump ( read motor
plate ) and supply network are same.
Installer must make sure that electric current network
has ground wire conforming to current laws.
Make sure that electric current network is provided with a
high-sensitivity circuit-breaker
=30 mA (DIN VDE 0100T739)
GB
Please refer to Fig. 1
WEIGHT
Kg.
8,5
9
10
5