Makita BHR200 Manual De Instrucciones página 8

Side grip
1
003141
The side grip swings around to either side, allowing easy
handling of the tool in any position. Loosen the side grip
by turning it counterclockwise, swing it to the desired
position and then tighten it by turning clockwise.
Bit grease (optional accessory)
Coat the bit shank head beforehand with a small amount
of bit grease (about 0.5 -1 g; 0.02 - 0.04 oz.). This chuck
lubrication assures smooth action and longer service life.
Installing or removing the bit
Clean the bit shank and apply bit grease before installing
the bit.
2
1
003150
Insert the bit into the tool. Turn the bit and push it in until it
engages.
1
2
003157
If the bit cannot be pushed in, remove the bit. Pull the
chuck cover down a couple of times. Then insert the bit
again. Turn the bit and push it in until it engages.
After installing, always make sure that the bit is securely
held in place by trying to pull it out.
To remove the bit, pull the chuck cover down all the way
and pull the bit out.
1. Side grip
1. Bit shank
2. Bit grease
1. Bit
2. Chuck cover
8
003166
Bit angle (when chipping, scaling or
demolishing)
1
003170
To change the bit angle, depress the lock button and
rotate the change lever so that the pointer points to the
"O" symbol. Turn the bit to the desired angle.
Depress the lock button and rotate the change lever so
that the pointer points to the
that the bit is securely held in place by turning it slightly.
1
003174
Depth gauge
1 2
003179
The depth gauge is convenient for drilling holes of
uniform depth. Insert the depth gauge into the hole in the
grip base. Adjust the depth gauge to the desired depth
and then tighten the clamp screw to secure the depth
gauge.
1. Change lever
2
2. O symbol
symbol. Then make sure
1. Change lever
1. Depth gauge
3
2. Clamp screw
3. Grip base