Cleaning The Floor Brush (5); Storage - Beem Mirage Power Clean Manual De Instrucciones

7.2

Cleaning the floor brush (5)

Attachment (e) clogged or blocked
If the vacuum cleaner tube (e) is clogged or blocked for any reason, this will reduce the
performance of the vacuum cleaner. In this case the tube will have to be cleaned:
1. Push the lever (f) and take out the floor brush (5).
2. Remove the blocking material with a suitable tool.
3. Push the lower tube of the base body (3) into the floor brush (5).
Small wheels (d) blocked
There are three small wheels (d) on the underside of the floor brush (5). If one of the
small wheels (d) is blocked by dirt or dust, the floor may scratch when vacuuming.
4. Loosen the small wheel (d) carefully with a screwdriver.
5. Remove the dirt so that the small wheel can rotate freely again on its axle.
6. Put the small wheel (d) back in its original position.
7.3

Storage

The vacuum cleaner locks in place in the upright position. This means you can put it
easily in a small corner to save space.
Optional for the upholstery brush (17) or the crevice nozzle (16) there is a practical
mounting on the rear of the base body (3).
BEEM – Elements of Lifestyle 25 / 68