BoomToneDJ VHF ONE VHF ONE Manual De Instrucciones página 11

USING THE VHF ONE - HANDMIC VERSION
1 / Remove the packing material, and keep it.
2 / Plug the power supply adaptor into the power supply connector on the
back side of the receiver.
3 / Connect the audio connector.
4 / Fully extend the antenna.
5 / Open the handmic battery cover and insert the 2x AA 1.5v batteries.
6 / Turn ON the receiver. The power indicator will light up.
7 / Turn ON the handmic, if the light is always lighted, your batteries are
defective.
8 / As soon as handmic is turn ON, RF indicator on receiver must light up.
9 / Adjust the volume on the receiver, you are now ready to use your microphone
wireless system.
USING THE VHF ONE - HL VERSION
1 / Remove the packing material, and keep it .
2 / Plug the power supply adaptor into the power supply connector on the
back side of the receiver.
3 / Connect the audio connector.
4 / Fully extend the antenna .
5 / Open the belt pack battery cover and insert the 2x AA 1.5v batteries.
6 / Connect the headset (or lavalier mic) cable to the belt pack.
7 / Turn ON the receiver. The power indicator will light up.
8 / Before turning ON the belt pack transmitter, set up the volume to the minimum.
9 / Turn ON the transmitter, if the light is always lighted, your batteries are
defective.
10 / As soon as handmic is turn ON, RF indicator on receiver must light up.
11 / Adjust the volume on the receiver, and on the transmitter .You are now ready
to use your microphone wireless system.