HTC HTT-31 Manual Del Operador página 4

!
All attachments, besides the table top, are done with
the following hardware: Phillips Machine Screw ,
a lock washer C, and a Nut with a Nylon Inset B.
1
Insert rubber feet F onto ends of legs G.
Notice: the correct end has two rectangular holes.
2
Attach the Long Center Frame
Support H to the legs G.
Repeat again with remaining
parts H and G.
3
Attach the two Short Center
Frame Supports I to one of the
assembled sides from Step 2.
4
Attach the remaining assembled side from
Step 2 to the parts assembled in Step 3
(rubber feet on the floor).
4