Twin-Star International 20IF100GRA-C202 Manual De Instrucciones página 6

OPERATING INSTRUCTIONS CONTROL FUNCTIONS
- POWER
The POWER button supplies power to all of the functions
of the fireplace. The POWER button will put the insert in a
standby mode. This will turn off all functions and hold the
settings in the memory. By pressing the POWER button
again the unit will turn onto at the same settings.
NOTE:
Holding the POWER button on the control panel for
10 second will disable the heater function.
- FLAME
1. Pressing the FLAME button will turn on and off the flame
effect.
2. When pressing the FLAME button the display will
enter flame setting mode.
3. There are 5 flame settings that can be selected with the
▼▲ buttons.
- HEATER
1. Pressing the HEATER button will turn on and off the heat
function.
2. When pressing the HEATER button the display will enter
temperature setting mode.
3. When in temperature setting mode pressing the ▼▲
buttons will change the thermostat by 2 °F (1 °C.)
The temperature setting range is between 62 °F - 82 °F
(17 °C and 27 °C).
4. The default temperature is 72 °F (22 °C.)
NOTE: To change between °F and °C press and hold the HEATER button on the control panel for 10 seconds.
NOTE: After the heater function or power is shutoff the blower will continue to run for several minutes to cool the
internal components.
- TIMER
Press the TIMER button will cycle through the 10 timer settings (30 minutes, 1 Hour, 2H, 3H, 4H, 5H, 6H, 7H, 8H
and 9H) and the OFF setting.
NOTE: PLEASE OPERATE REMOTE TRANSMITTER AT A SLOW
MEASURED PACE. PRESS THE REMOTE CONTROL BUTTONS
WITH AN EVEN MOTION AND GENTLE PRESSURE. REPEATEDLY
PRESSING BUTTONS IN RAPID SUCCESSION MAY CAUSE THE
TRANSMITTER TO MALFUNCTION.
Figure 5
E-5
Figure 4