Remote Control - AEG BSS 4816 Instrucciones De Servicio

English
42
For optimum installation of the loudspeakers, please fol-
low the instructions below:
Connection
CAUTION:
• Switch off the subwoofer before connecting the speak-
ers or modifying the connection.
• Make sure that the uninsulated speaker wires do not
touch/cross. Risk of short circuiting!
• Do not operate the unit at maximum volume. This may
lead to damage.
• Never connect the speakers to the mains!
• Never touch the speaker membranes with your hands
or with objects. Doing so may damage the membranes.
• Do not overload the speaker boxes.
NOTE:
Please ensure
• that the plug-in connectors are firmly in place. Poor
connections can result in interference.
• that exposed wires do not touch or cross each other.
Danger of short-circuiting!
1 Antenna connection
Plug the supplied FM wire antenna onto the connection.
2 5.1CH INPUT (5.1 connections)
Used for connecting an external sound source to a 5.1
output (e.g. DVD player).
NOTE:
The device has an analogue 5.1 connection for an AC3
or DTS decoder.
3 2CH/AUX (2.1 connections)
For connection of an external sound source with normal
stereo recording (e.g. hifi video recorder).
4 SPEAKER OUTPUT
• Outputs on the right and left for connection of the
front loudspeakers (FR/FL).
• Outputs for connection of the surround speaker
boxes right and left (RR/RL).
• Output for connection of the centre loudspeaker
(CEN).
1. Remove around 1.5 cm of the cable insulation.
2. Twist the end of the cable.
3. Open the cable terminal by pressing on the latch.
4. Now connect the speaker cable of the respective box
to the corresponding connection on the subwoofer.
Check that the polarity is correct. (Polarity " " from
speaker to " " from the subwoofer and " " to " ".)
5 POWER ON/OFF switch
With this switch the system can be switched on and off.
6 Mains lead
Power supply
When you have connected all loudspeakers and devices as
described you can insert the mains plug of the subwoofer
into a correctly installed 230 volt, 50 hertz power socket.

Remote Control

Inserting the battery/batteries
(battery/batteries not supplied)
• Open the lid of the battery compartment on the back of
the remote control.
• Insert 2 batteries of type R03 "AAA" 1.5 V. Ensure that the
polarity is correct (see the floor of the battery compart-
ment)! If the remote control is not used for a prolonged
period, remove the batteries in order to prevent battery
acid leaking.
• Now close the battery compartment.
CAUTION:
• Different battery types or new and used batteries must
not be used together.
• Batteries are not to be disposed of together with
domestic wastes. Dispose of the used batteries at the
relevant collection bin or at your dealer' s .
WARNING:
Do not expose batteries to any intense heat, such as sun-
light, fire, or similar. There is a danger of explosion!
When the remote control is used, care should be taken that
there are no objects between the remote control and the
central loudspeaker. (e.g. table, chair, etc.). These objects pre-
vent the infrared beam of the remote control from reaching
the receiver of the central loudspeaker. It is then not possible
to control the television with the remote control.