Automatic Operation; Setting The Clock - Brandt CFP-1015 Manual De Instrucciones

it will disconnect automatically after 2
hours.
• During these 2 hours, the hotplate (5)
will keep your coffee hot.
• The coffee maker has an anti-drip
system to prevent the coffee dripping
onto the hotplate when the jug is not
correctly in place or when it is removed
from the appliance.
• With the aroma control button it is
possible to regulate the strength of the
aroma of the prepared coffee. You may
select from a gradual range of mild to
strong.

7. AUTOMATIC OPERATION

Setting the clock

Once the coffee maker is connected to
the mains, the message <<00:00>> will
flash up on the LCD display screen (10). To
adjust the time, the coffee maker should
be switched off. Press the "h" hour setting
(15) or the "m" minute setting button (16)
until you obtain the correct timing. The
appliance uses a 24 hour format.
NB: In the event of an electrical power
cut or when disconnecting the main cord
from the coffee maker, the set time will be
deleted from memory.
Automatic setting
• The coffee maker should be off to set
the start time.
• To select the start time, keep the setting
button (17) pressed down while pressing
the "h" hour setting (15) or "m" minute
setting button (16), until you obtain the
desired time.
• To set the start time that you have
selected, press the "auto" button (12).
The green light (12) will come on.
• At the set time, the coffee maker will
start to operate automatically. The red
light (14) will come on and the green
light (13) will go off.
8. TIPS FOR MAKING A GOOD
CUP OF COFFEE
To give your coffee a better flavour and
aroma, we advise using recently ground
coffee.
The coffee should be medium ground and
not too fine.
Store the coffee in a dry place. Once the
packet of coffee has been opened, you
may store it tightly closed in the refrigerator
to ensure that it maintains its aroma.
The best coffee is obtained by drinking it as
soon as it is made.
9. CLEANING
Before cleaning your coffee maker,
switch off the on/off switch
appliance and wait until it has cooled.
Clean the filter holder (9), the filter (8), the
jug (4) and the lid (3) of the jug in warm
soapy water, rinse in clean water and dry
the parts before reassembling them.
Clean the exterior of the coffee maker with
a damp cloth. Do not use detergents or
abrasive products to clean it.
Do not immerse the appliance in water
or run it under the tap.
10. REMOVING LIMESCALE
Depending on how hard the water is in
your area and how often you use the coffee
maker, it is possible that the pipes may
become blocked due to the lime content
of the water. This is noticeable when the
filtering process lasts longer than usual.
In order to avoid this, you should remove
limescale from the coffee maker using
products suitable for coffee makers which
are readily available on the market.
11
, unplug the