Dolmar MC-CS1 Manual De Instrucciones página 9

Lubricating moving parts
NOTICE:
Follow the instruction of the fre-
quency and amount of grease supplied. Otherwise
insufficient lubrication may damage moving parts.
Gear case:
CAUTION:
Do not apply grease when the
gear case is hot. Hot gear case can cause burn
injury.
Fill approx. 30 ml of grease (Shell Alvania 2 or equiva-
lent) through the grease port evenly every 25 hours of
operation.
With the supplied hexalobular wrench, remove the bolt
near the lubrication marking on the gear case. Loosen
the bolt on the other side so that the air in the gear case
can be released when applying the grease.
After applying the grease, be sure to tighten the bolts.
1
2
► 1 . Bolt 2. Gear case
Interval of inspection and maintenance
Whole unit
All fixing screws and nuts
Rotor blades and protector
Gear case
Drive axle
Power unit
Operating hour
Visually inspect for damaged parts
Tighten
Clean and visually inspect for dam-
aged parts
Supply grease
Supply grease
Refer to the instruction manual of the power unit
Drive axle:
Apply grease (Shell Alvania No.2 or equivalent) every
25 hours of operation.
NOTE: Genuine Dolmar/Makita grease may be pur-
chased from your local Dolmar/Makita dealer.
Storage
WARNING:
tions in the chapter "SAFETY WARNINGS" and
the instruction manual of the power unit.
When storing the attachment separated from the power
unit, put the cap onto the end of the shaft.
Before
Operation
-
-
-
9 ENGLISH
Follow the warnings and precau-
Daily (10h)
-
-
-
-
25h
-
-
-