Service And Maintenance - Gorenje TCM 200 - 300 Instrucciones De Uso

SERVICE AND MAINTENANCE

After the connection to the water supply mains and other heating sources heat pump water heater is ready for use. If there is any
possibility the water in the tank could freeze, you must drain the water from the tank. To do so, open the hot water lever at one of the
mixing batteries, connected to the hot water tank. The water is drained via a drain valve on the inlet water pipe.
To clean the exterior of the appliance, use a soft cloth and a mild detergent. Avoid cleaning agents containing alcohol and abrasive
cleaners. If the appliance is exposed to dust, evaporator lamellas might become blocked, which can have a detrimental effect on the
functioning of the appliance.
By providing regular service check-ups, you can ensure flawless operation and long life of the heat pump. The corrosion warranty for
the tank only applies if you carry out regular inspections of the protective anode. The period between inspections must not exceed 36
months. The inspection must be performed by an authorised expert. The inspection must be marked on the warranty document of the
product. The inspection will check the anti-corrosion protection anode and if necessary clean the limescale, which builds up in the
tank depending on the quality, quantity and temperature of water. The maintenance expert will recommend the date for the next
inspection.
Despite careful production and control, errors may occur during heat pump water heater operation, which must be resolved by an
authorised service technician.
Before calling your maintenance provider, check the following:
• Is everything OK with the power supply network?
• Is the air outlet obstructed?
• Is the environment temperature too low or too high?
• Can you hear the operation of the compressor and fan?
Do not try to eliminate malfunctions by yourself, call your nearest authorized service provider!
Our products incorporate components that are both environmentally safe and harmless to health, so they can be
disassembled as easily as possible and recycled once they reach their final life stage.
Recycling of materials reduces the quantity of waste and the need for production of raw materials (e.g. metals) which
requires a substantial amount of energy and causes release of harmful substances. Recycling procedures reduce the
consumption of natural resources, as the waste parts made of plastic and metal can be returned to various production
processes.
For more information on waste disposal, please visit your waste collection centre or the store where the product was
purchased.
WE RESERVE THE RIGHT TO ANY MODIFICATIONS NOT AFFECTING THE FUNCTIONALITY OF THE APPLIANCE.
The instructions for use are also available on our website http://www.gorenje.com.
23