Charging The Speaker - Dcybel Cube Manual De Instrucciones

Accessories
Micro USB cable
When the USB cable is used as the disconnect device, the disconnect
device shall remain readily operable.
The marking plate is located at the bottom of the apparatus.

CHARGING THE SPEAKER

The speaker has a built-in Lithium battery. It is recommended to charge
the internal battery for about 3 hours before using the speaker.
The fully-charged battery can give up to 5-hour playing time depending
on genres of music and volume.
1. Connect the small end of the supplied micro USB cable into the
charging port of the speaker. Connect the other end of the cable into
the USB port on your computer.
The charging indicator light will illuminate red.
2. When the battery is fully charged, the red indicator light will go out.
3. After charging, remove the micro USB cable.
EN-3
3.5 mm audio cable
Low battery warning:
When you hear several low-pitched tones
during playing music, please recharge the speaker.
PARING WITH A BLUETOOTH-ENABLED DEVICE
1. Turn on the speaker by setting the ON/OFF switch at the rear of the
unit to the ON position.
The speaker will enter Bluetooth mode and the indicator light at the
front panel of the unit will flash blue.
2. To pair, go to Bluetooth settings on your Bluetooth enabled device and
connect to "Cube".
Mode
Bluetooth pairing The Bluetooth indicator light will flash blue.
You will hear several high-pitched tones and the
Bluetooth indicator light will stop flashing.
NOTE:
Paired
Once the Bluetooth device is connected for the first
time, the speaker will remember the paired setting
and will automatically reconnect to the same
Bluetooth device the next time they are in range.
Status
EN-4