Doro HandleEasy 321rc Manual De Instrucciones página 5

3. From a distance of approx. 1 in. to 4 in., point the remote
control of the equipment towards HandleEasy and press
the corresponding button. If HandleEasy was successful in
learning the signal, the indicator will flash twice. If there is
an error, the indicator will flash six times. If necessary hold
down the button of the equipment for up to 10 seconds to
succeed with the learning.
4. Press the same button on HandleEasy once again. The
indicator will flash once.
5. Press the corresponding button on the remote control of
the equipment once again. If HandleEasy was successful
in learning the signal, the indicator will flash twice.
HandleEasy has now learned the double signal.
Repeat steps 2 to 5 for each button utilizing a double signal,
or if the learning fails. HandleEasy is now ready for operation.
Keep both
ON
learning mode.
Troubleshooting
If HandleEasy only works now and then or jumps double
steps, you must program it to utilize a double signal.
Two consecutive learnings per button must be successful,
when programming a double signal.
If learning fails even after repeated attempts:
• Try longer or shorter (1-10 seconds) press of the button on
the remote control of your equipment.
• Try different distances or angles between the remote
controls.
• Try replacing the batteries in the remote control of the
equipment.
If you cannot resolve the fault using the faultfinder section,
technical support is available by email on tech@doro-uk.com
or via a premium rate telephone number: 0905 895 0854,
calls cost 50 pence per minute (prices correct at the time
of publication). Further contact details are available on our
website: www.doro-uk.com
Alternatively you can write to:
Customer Services, Doro UK Ltd, 1 High Street,
Chalfont St Peter, Buckinghamshire SL9 9QE
and depressed or wait 10 seconds to exit
OFF