Symbol LRT 3840 Guía Rápida página 11

To cancel and set up a new Net ID (obtained from the
network administrator):
1. Press Ctrl+C to end the attempt. The terminal displays the
message:
Halt Batch process Y/N?
2. Type Y to exit to the DOS prompt (D:).
3. At the DOS prompt, type CFG24 and press ENTER to
initiate the Configurator and bring up the Configurator
screen:
CONFIGURATOR 1.XX
View config params
Net Id
Subnet Mask
Default Router
Terminal IP Address
Exit
-
, Clear, Enter
4. Use the UpArrow and DownArrow to cursor to Net ID.
5. The current Net ID appears in hex format. Backspace over
the existing value, type a new value in the range 102-1FE
(in hex, not case sensitive), and press ENTER.
6. Power the terminal off.
7. Cold boot again.
8. The terminal attempts to associate with an AP.
11