Proxxon LWB/E Instrucciones De Uso página 7

Working with the drill
Important:
Risk of injury. Do not operate this drill
unless you are wearing protective
goggles.
Never work with damaged grinding
discs or bent shanks.
Replace dull insert units promptly.
In the event of heavy dust ratio or
harm ful dust particles, wear a dust
mask.
1. Switch drill on at switch 2 (Fig. 3)
and select the appropriate speed at
dial 1.
Never use excessive bearing pressure.
Correct, uniform speed facilitates opti -
mum grinding.
Small milling cutters/shanks =
high speed
Large milling cutters/shanks =
low speed
2. Hold drill as shown in Fig. 4 so as
not to obstruct the ventilation slits 1.
If the drill overheats, switch it off
im me diately and allow it to cool.
Note:
Note:
Disposal:
Please do not dispose of the device in
domestic waste! The device contains
valuable substances that can be
recycled. If you have any questions
about this, please contact your
local waste management enterprise
or other corresponding municipal
facilities.
EC Declaration of Conformity
Name and address:
PROXXON S.A.
6-10, Härebierg
L-6868 Wecker
Product designation: LWB/E
Article No.:
In sole responsibility, we declare that
this product conforms to the following
directives and normative documents:
• EU EMC Directive 2004/108/EC
DIN EN 55014-1 / 02.2010
DIN EN 55014-2 / 06.2009
DIN EN 61000-3-2 / 03.2010
DIN EN 61000-3-3 / 06 2009
• EU Machinery Directive 2006/42/EC
DIN EN 60745-1 / 01.2010
Date: 10.02.12
Dipl.-Ing. Jörg Wagner
PROXXON S.A.
Machine Safety Department
The CE document authorized agent is
identical with the signatory.
28492
- 7 -