Fellowes Powershred 46Ms Guia De Inicio Rapido página 3

BASIC SHREDDING OPERATION
Continuous operation:
Up to 15-minutes maximum
NOTE: Shredder runs briefly after each pass to clear
entry. Continuous operation beyond 15-minutes will
trigger 25-minute cool down period.
ADVANCED PRODUCT FEATURES
SafeSense ® Technology
Stops shredding immediately when
hands touch the paper entry.
SAFESENSE ® TECHNOLOGY OPERATION
Stops shredding immediately when hands touch the paper opening.
SET-UP AND TESTING
1
2
Turn the shredder ON Touch test area and
(–) to activate SafeSense look for the SafeSense
®
indicator to illuminate
For more information about all of Fellowes Advanced Product Features go to www.fellowes.com
PRODUCT MAINTENANCE
OILING SHREDDER
All micro-cut shredders require oil for peak performance. If not oiled, a
machine may experience diminished sheet capacity, intrusive noise when
shredding, and could ultimately stop running. To avoid these problems, we
recommend you oil your shredder each time you empty your waste bin.
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
1 2
Press and hold forward
*Apply oil across entry
( ) 2-3 seconds
* Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
TROUBLESHOOTING
Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum operating temperature and needs to cool down. This
indicator will remain illuminated and the shredder will not operate for the duration of the recovery time. See Basic Shredding Operation for more information about
the continuous operation and recovery time for this shredder.
Bin Full: When illuminated, the shredder waste bin is full and needs to be emptied. Use Fellowes waste bag 36052.
Remove Paper: When illuminated, press reverse (
SafeSense ® Indicator: If hands are too close to the paper entry, the SafeSense
PAPER/CARD OR CD
1 2
Plug in and put Feed paper/card straight
disconnect power into paper/card entry
switch in ON (–) position and release
SilentShred™ Technology
SilentShred™ noise quality
shreds without noisy disruptions.
3
SafeSense is active and
®
working properly
®
CLEANING AUTO-START INFRARED SENSORS
Paper detection sensors are designed for maintenance free operation. However, on rare occasions the sensors
may become blocked by paper dust causing the motor to run even if there is no paper present.
(Note: two paper detection sensors are located in the center of the paper entry)
TO CLEAN THE SENSORS
1
Turn OFF ( ) and
unplug shredder
) and remove paper. Reduce paper quantity to an acceptable amount and refeed into paper entry.
or
Hold CD at edge, feed
into center of CD entry
and release
Sleep Mode
Energy saving feature shuts down
the shredder after 2 minutes
of inactivity.
SLEEP MODE OPERATION
Energy saving feature shuts down the shredder after
2 minutes of inactivity.
WHEN IN SLEEP MODE
1
In sleep mode
2
Locate Auto-start
infrared sensor
® indicator will illuminate and the shredder will stop shredding.
3
When finished shredding
set to OFF ( )
Auto Reverse
Stops and reverses paper
if a jam occurs.
2
insert paper
.
4
3
Dip cotton swab in Using cotton swab, wipe
rubbing alcohol away any contamination
from the paper sensors
3