Technical Data; Problems And Solutions - Orbegozo SA 2150 Manual De Instrucciones

Facial sauna
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ABSTERGING DIRT FROM BOILER
It can be prolong the lifetime to absterging regularly.Do it every 2 to 3 months or use after 20 times
1. Take off the facial mask
2. Use vinegar that not mix water(acetic is 8%) with half of boiler also
3. Keep liquid into boiler about 20 minutes
4. Drop the liquid out of boiler and use soft cloth scrub of boiler
5. Repeat above operation can clean any remain of watersmear.
Not let face near the facial mask when haze appear after first use the product just be cleaned, due to
the product may have the remain of vinegar or the dose of detergent.

TECHNICAL DATA

Technical: AC110-240V 50/60Hz 80-100W

PROBLEMS AND SOLUTIONS

Problem
Indicator is unlit
Little steam or none steam
Make sure the on/off knob is
set. Make sure the openings
in the bottom of the
steaming mask are not
obstructed.
Disposal of old electrical appliances.
The European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE),
requires that old household electrical appliances must not be disposed of in the normal
unsorted municipal waste stream. Old appliances must be collected separately in order to
optimize the recovery and recycling of the materials they contain, and reduce the impact on
human health and the environment.
The crossed out "wheeled bin" symbol on the product reminds you of your obligation, that
when you dispose of the appliance, it must be separately collected.
DECLARATION OF CONFORMITY:
This device complies with the requirements of the Low Voltage Directive 2006/95/EC and the requirements
of the EMC directive 2004/108/EC.
SA 2150
Some parts unassembled
The appliance is not switched on
or the openings in the bottom of
the
steaming mask are obstructed
There is an additive (e.g. oil) or a
foreign substance (e.g. washing-
up liquid)in the water container.
Reason
Plug uncorrectly or no power
Check power plug into main outlet
Water is unenough
Solution
Use measurement cup to fill
with waters with 40ml
Check assemble of bottom
of product,and also facial
basket.
Make sure the on/off knob
is set.
Make sure the openings
in the bottom of the
steaming
mask are not obstructed.
Unplug the appliance and
remove the steaming mask
and aroma diffuser. Clean
the steaming mask and the
aroma diffuser with fresh
water. Wipe the base of the
appliance with a moist
cloth. Do not clean the base
under the tap as it contains
electrical parts
10

Publicidad

Tabla de contenido
loading

Tabla de contenido