Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
6. Attach Side Back Panels (I) and Center Back Panel
(J) to the back of the completed assembly from step
5. Use a Phillips Head Screw Driver, tighten Wood
Screw (DD) through the pre-drilled holes in the
Back Panels (I,J).
Hardware Used
DD
Wood Screw
7. Choose desired height of Shelf (H) and place the
four Shelf Pin (EE) into same height shelf holes
inside side panels. Insert Wood Shelf (H), allow
Wood Shelf (H) to rest on the Shelf Pin (EE).
The Mantel must be level for the proper functionality
of doors and as a safety precaution.
Hardware Used
EE
Shelf Pin
8. PLEASE READ ALL "ELECTRIC FIREPLACE
INSERT" INSTRUCTIONS PRIOR TO
INSTALLING ELECTRIC INSERT IN YOUR
COMPLETED FIREPLACE MANTEL. INSTALL
THE INSERT IN YOUR FIREPLACE CLOSE TO
ITS FINAL POSITION.
Lift insert carefully into the back of the unit and
center in the insert opening. Do not drag insert
across hearth/base as it may scratch the unit.
Connect the Insert Support Bar (N) to the inside left
and right panels, using the bolt (AA) and washer
(BB) through pre-drilled holes.
MOVE YOUR COMPLETED UNIT ONLY SHORT
DISTANCES. MOVE COMPLETED UNIT WITH
GREAT CARE. IT TAKES TWO PEOPLE TO
MOVE COMPLETED UNIT INTO ITS FINAL
POSITION.
Hardware Used
AA
Bolt
BB
Flat Washer
Fig. 6
x 30
Fig. 7
x 8
Fig. 8
Completed
Unit
x 2
x 2
6
J
I
DD
H
EE
Install
Insert
From
Back
Electric
Fireplace Insert
N
AA
BB
I
08/18/11
Publicidad
Tabla de contenido
