Connecting Cable To Radiator Controller; Limiting The Adjustment Range (Optional) - Honeywell Hometronic HCW 23-K Instrucciones De Montaje

4. Connecting cable to radiator controller

1. Lift side cover (A) of the radiator controller by means of screwdriver
(see Fig. F).
2. Place the cable plug into female connector at the radiator controller and let
snap in.

Limiting the adjustment range (optional)

To limit the adjustment range of the remote setpoint adjuster :
1. Remove the regulator wheel of the remote setpoint adjuster .
2. Place the two small pins in the holes of the regulator wheel in order to limit
adjustment range. For temperature ranges, refer to the scale near the
centre:
In Fig. B for example, the pins are placed in such a manner, that the
regulator wheel can only be adjusted by ±3 C from position 0.
3. Place the regulator wheel back onto the remote setpoint adjuster housing
and move the wheel clockwise to stop.
4. Ensure that the regulator wheel is in the position shown in Fig. B.
If this is not the case: Lift the regulator wheel, turn it by 90° and put it into
position as shown in Fig. B.
5. Turn the regulator wheel to position 0 (see Fig. B) and return the cover to
the housing.
7