Starting-Up The Unit; Using The Unit - BOMANN KG 1293 CB Instrucciones De Servicio

Parrilla de contacto
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 14
GB
Non-stick coating
Grease the grill plates slightly before using for the fi rst time. Use the appliance
for 10 minutes with the grill plates closed and without food (see use of the
appliance). Then wipe them clean with a moist cloth.
1. Insert the fat collection tray in the front opening. Put the plug into an earthed
230 V, 50 Hz mains socket.
Mains control lamp
As soon as you have inserted the plug the green mains control lamp lights up
and indicates that the device is connected to the mains.
Warm-up time
The warm-up time is approx. 5 min. During this time you should keep the
grilling surfaces closed.
2. When the red control lamp lights up the grilling temperature has been reached.
3. Open the cover and place the food to be grilled. Then close the lid gently.
4. Grilling is fi nished after 8 to 10 minutes (depending on the thickness of the
food being grilled).
5. Open the cover and remove the cooked food with a wooden fork or similar
kitchen utensil. Do not use any sharp or cutting objects as they may damage
the coating of the grill plates.
6. When food is not being grilled the grill surfaces should always be kept closed.
Switching off
In order to stop the cooking process remove the mains plug from the socket.
Always pull out the plug from the mains socket before cleaning and wait until
the unit has cooled down.
Do not use any wire brush or other abrasive objects.
Do not use any acidic or abrasive detergents.
Under no circumstances should the device be immersed in water for cleaning.
Heating Plate
Please remove any food residues while they are still warm with a damp cloth or
paper towel.
Clean the heating plate with a soft sponge and soapy water. Then wipe off with
clear water and dry thoroughly with a soft cloth. After drying please apply a
thin fi lm of edible oil to the surface.
32
05-KG 1293 CB New 32

Starting-up the unit

Using the unit

Cleaning
31.08.2005, 12:57:53 Uhr

Publicidad

Tabla de contenido
loading

Tabla de contenido