Maintenance Guide - Preval vFan Manual De Piezas E Instrucciones

www.preval.com
The vfan PorTable airbruSh SySTem

MaIntenance GuIDe

See our video — vFan Maintenance: inSpecting the needle at
tinyurl.com/vfan-needle
removinG/rePlacinG The needle and handle (illustration a):
1. Unscrew the handle and loosen the locknut
Depress the trigger
inserting the needle. This assures the needle will move freely through the
trigger. Gently remove the needle
force out. Do NOT bend.
2. Inspect the condition of the needle. If it is bent or misshapen in any way,
replace it with a new needle. A bent needle can damage or split the tip,
causing bubbles or a rough spray pattern. The sharp end of the needle
bends easily.
3. Hold trigger in DOWN position, insert the new needle into the rocker assembly
8
. Gently push needle through, rotating if necessary, push gently forward
until the needle stops in the front of the tip.
4. Release trigger and tighten locknut by turning clockwise.
diaGram of The vfan airbruSh (illuStration B)
TOP VIEW
Page 8
7 and hold in DOWN position while removing or
, rotating if necessary. Do NOT
17
7
OPENING FOR #7 TRIGGER
SHOWING BALL ON TOP OF
AIR VALVE FOR ASSEMBLy #14
by turning counterclockwise.
11
17
NEEDLE TO
PASS THROUGH
END VIEW
7