Midland BT NEXT Manual De Instrucciones página 22

The connection is not a "chain", when two person are talking it is not possible to
break (interrupt) the communication by one of the other two units riding out of the
maximum distance range.
Pair the BTNext to another BTNext unit
To pair the BTNext to another BTNext unit, you must first enter the setup mode:
1. Turn off the unit
2. Press and hold down the middle button about 7 sec., until the Red light is on
permanently.
3. Now press one of the three buttons (Forward, Middle or Rear) for 3 seconds de-
pending on which button you would like use to open the intercom to the other
unit. The Blue and Red light will flash.
4. Repeat the same procedure on the other unit, you don't need to use the same
button, you can choose one of the three buttons not previously used.
5. When successfully paired, each unit will have the Blue light on for one second
and then go back to the setup mode (Red light always on). Now the unit is ready
for another pairing procedure, and you can pair another BTNext unit following
the same procedure, but using a different button.
If you don't have more devices to pair, you must exit the setup mode before you can
use the units:
› Double click on the Middle button, the Red light will turn off and the Blue light
will start flashing.
You can use now your BTNext.
How to use the Intercom with more than two units
To use the intercom feature, be sure that all the units are turned on and correctly
paired together
Attention: For intercom communication between Driver and Passenger there is no
need to keep the flip-up antenna in the up position. For Bike to Bike intercom the an-
tenna must be in the upper position.
Manual activation
Press the button corresponding to the unit you would like to communicate with.
After about 4 seconds the intercom communication will open.
The communication remains active until you press again the same button. To quickly
open the intercom to another person, just press the button corresponding to the
A- Manual activation
Mode Forward button
Intercom Short press: Open/Close intercom to paired
raider
other unit, the intercom will be automatically closed and the new connection will
be open (see Table A).
Voice activation (VOX)
The voice activation feature can open the intercom only to the unit paired to the
Middle button. While no other communication is open, simply start talking and the
communication will be open and remain active for all the time you are talking. If
there is no conversation the intercom will be closed after 40 seconds. If needed you
can close the intercom manually without waiting 40 seconds, pressing the Middle
button.
If needed, you can disable the VOX feature simply by pressing the Backward button
for 7 sec. A voice announcement will advise you when the VOX is disabled. To turn the
VOX on again, just press the same button and a voice announcement will advise you
that the VOX is now active. This setting is remembered also in you turn off the unit.
Hint: this feature is very useful when you have a specific person that you like to
talk to more often (for example your passenger). In this way you don't need to
press a button to open the communication.
Unit already busy
If you try to open a intercom connection to another person that is already busy
talking with some one else (or is in a middle of a phone conversation), you will hear
a "busy" double beep tone. Just wait sometime and try again, maybe this time the
"line" is not busy.
The person who is called, will be advised that someone is trying to call and will hear
a voice announcement with the number of the button from which the request is
coming.
In this way as soon as the first conversation is over, the person can easily contact
the caller by opening the intercom of the specific button number (indicated by the
voice announcement).
Middle button
Short press: Open/Close intercom to paired
raider
Long press: Change mode
1 2 3
Rear button
Short press: Open/Close intercom to paired
raider
Long press: Toggle on/off wired
Midland BT Next - 21