User Preset - NEO NEXUS SWITCH 24 Manual De Usuario

status, then the Mode only can be set as SIN-
GLE,HTP or LTP.
4. Protocol, can be set as ArtNet/ sACN/ KlingNet;
5. Framerte/fs, adjust the speed of DMX output.
6. Principal, adjust the value.
7. Secondary, adjust the value.
8. Resend, adjust or disable the value for universal
of network.
9. Pixel Type, available under klingnet protocol.
10. Pixel Width, available under klingnet protocol.
11. Pixel Height, available under klingnet protocol.
Normal mode means it will send the data received
from DMX IN port to the universal of network re-
gardless if there is any data in the universal of the
network.
Backup mode refers that when there is any data
on the universal of network, the CA-AN08 won't
send any data to universal of network. Only when
the universal of network is no any data, then the
CA-AN08 will receive the data from DMX IN port and
send it to the universal of network simultaneously.
Single means this port will only output one univer-
sal. LTP means this port will output the latter one
between the universal of principle and secondly.
The unit will compare the two universal and resend
the later one to the network.
HTP means the port will output the one with higher
value between the universal of principle and sec-
ondly. The unit will compare the two universal and
resend the higher data to the network. They can be
set within the range of 0.0-F.F./001-255. (These two
formats can be change through Display Mode). 1-24
DMX port disabled:
Any of the port 1-24 can be set as Disabled status.
Upon the port has been set as Disabled status,
the DMX port will be disabled, it cannot send or
receive any data from now on.
Please note that the Framerte/fs only available
for Output status; The Secondly and Resendop-
tiononlyavailablefor the HTP/LTPmodeunder
thestatusof Output.
Set ID NO.
Enter into the main menu by press MENU button,
pressing UP and DOWN to choose the Set ID NO.
option, then press the ENTER to confirm your
selection. You can set the ID No. for the unit from
000 to 255. The ID is only used to recognize each
of the unit easily.

User Preset

Enter into the main menu by press MENU button,
then pressing the UP and DOWN to choose the
User Preset option and then press the ENTER
to confirm your selection. This setting help you
easily use the application avoid complicated set-
P. 7
English version - Neo Nexus Switch 24