Installation Instructions; Safety Notes; Technical Data - Bauhaus 79155/2 Instrucciones De Montaje

Installation instructions

GBR
Dear customer,
You have purchased a high-quality and long-
lasting product from our line of goods. Please
read these instructions carefully before assem-
bling and observe the notes.
These instructions contain important infor-
mation on installation, adjustment, care, and
spare parts.
Therefore, keep the instructions in a safe place
and pass them on to possible subsequent
owners.

Safety notes

• Only allow experts carry out the installation
work.
• CAUTION DAMAGE BY WATER!
Prior to installation please turn the general
water supply off.
• Ensure that all gaskets have the correct fit.
• These taps are not suitable for use on low
pressure and small electrical storage heaters.
• We recommend the installation of a filter
into the appliance or at least the use of angle
valves with filter, in order to avoid the inflow
of foreign matter, which could damage the
cartridge.
• This tap is only intended for use in private
households! Only suitable for use in rooms
with a temperature over 0° C, when there is
danger of frost, sut off the water supply and
empty the tap.
• If the tap not used for a longer period, we
recommend to initially let a larger quantity
of water flow through before withdrawing
drinking water.
• Take care when adjusting the warm water.
Danger of scalding!
Disposal
Your washbasin tap is delivered in a solid pa-
ckaging, in order to protect it against transport
damages. The packaging consists of recyclable
materials. Dispose it in an environmentally
suitable manner.
Do not throw the product into the normal
domestic waste at the end of its service life,
but ask your municipal administration about
the possibility of an environmentally friendly
disposal.

Technical data

• Flow pressure: recommended 1.5 bar; install a
pressure reducer at more than 6 bar
• Water temperature: max. 80°C
• Water connection: warm - left/cold - right
Installation Instructions
• Only hand-screw the connecting pipes, do
not use pliers or a wrench!
• After installation unscrew the mixer noz-
zle, flush the pipeline and the tap very well
(warm/cold water supply), in order to flush
out contaminations (swarf and hemp remain-
ders). After flushing, screw the mixing nozzle
onto the spout again.
• Do not twist or tension pipes! At first use
check connections for leaktightness!
• We do not assume any warranty for incorrect
installation - in particular for subsequent
damages!
5