How to fill rinse aid
Rinse aid
This product makes dishes sparkle and helps them to dry without spotting. The dispenser is located on
the inside panel of the door .
When the low rinse aid indicator " 1 " is bright, it means the
rinse aid is low, you must load rinse aid .
Loading the rinse aid
Regardless of the type of detergent dispenser installed on
your appliance, you must proceed as indicated below when
loading the rinse aid.
To open the dispenser, turn the
direction and then pour in the rinse aid, making sure not to
overfill. The amount of rinse aid used for each cycle can be
regulated by turning the "
3"
dose adjustor, located beneath
the
"2"
cap, with a screwdriver. There are 6 different settings;
the normal dosage setting is 3.
Important
Proper dosage of the rinse aid improves drying.
If drops of water remain on the dishes or spotting occurs, the dosage ad-
juster should be turned to a higher setting.
If the dishes have white streaks, turn the dosage adjuster to a lower setting.
"2"
cap in an anti-clockwise
1
Low
Full
2 3
en
10