Timer setting
•
Press the mode button [D] repeatedly until the timer icon [3] is
displayed.
•
Press and hold the set button [E] for ±2s, the minutes start flashing.
Modify using the up [F] or down [G] button (max. 199).
•
Press the set button [E] again, the seconds start flashing. Modify with
the up [F] or down [G] button.
•
Press the set button [E] again to save the timer setting.
•
Press the up [F] or down [G] button to start or stop the countdown.
•
When the counter reaches 00:00, the alarm sounds. To stop the alarm,
press any button [D, E, F, G] or touch the border [A] when touch
control is enabled.
Temperature mode
•
Press the mode button [D] repeatedly until the temperature is
displayed.
•
Press the up [F] or down [G] button to switch between °Celsius or
°Fahrenheit display.
Troubleshooting
•
Should the clock or sensor not react anymore, remove and re-insert the
batteries (see §7). When the problem remains, use a small screwdriver
to gently press the reset button [C].
7. Batteries
•
Open the battery cover [J] at the back of the clock.
•
Insert three new type AAA (LR03C) batteries with polarity as
indicated inside the battery casing.
•
Close the battery compartment.
•
Do not attempt to recharge non-rechargeable batteries and do not
throw batteries in fire as they might explode.
06/01/2009
WARNING: handle batteries with care, observe
warnings on battery casing. Dispose of batteries in
accordance with local regulations.
Keep batteries away from children.
WT8093
6
©Velleman Components nv
®