Gama Sonic Light My Shed GS-16 Manual De Instrucciones página 4

4. Lamp Installation
Select the desired location for the lamp inside the shed. Ensure the solar module
cord reaches the lamp. Use the lamp base sides to mark and drill 2 holes (as
shown in figure 5). Use 2 screws and nuts* to fasten the lamp to the wall.
Figure 5
* Included in the kit
5. Operation
Plug the solar module cord into "DC-IN" Socket located on top of the lamp. Charge
for 2 days for best performance.
Use the pull cord for ON/OFF operation.
Select 1 lamp for longer run-time or 2 lamps for a brighter light.
REMEMBER TO SHUT OFF THE LAMP WHEN LEAVING
THE SHED TO PRESERVE BATTERY CHARGE
6. Maintenance
Clean the solar module with a damp towel to guarantee optimum performance of
the solar panel. Do not use any type of solvent for cleaning and be careful not to
put too much pressure on the module while cleaning.
NOTE: The performance of "Light my Shed" will vary with the time of year.
The duration of the light will be longer when the solar panel has had a full day in
the sun rather than a day in overcast weather.
WINTERTIME TIPS: Keep snow and debris off the solar panel so the batteries can
recharge. If the solar panel is covered with snow for an extended period of time,
after the snow melts, allow all the batteries to charge in full, direct sunlight for at
least 6 hours to their maximum capacity.
WARNING: Please keep out of reach of children.
4